Good question, because the best thing you can do by far on your motorhome is to install a rear anti-sway bar because they are a vast improvement over the OEM sway bars with thicker construction for the greatest reduction in sway and improvement in overall handling. After that you can further improve the ride by adding a front anti-sway bar, but definitely start with a rear anti-sway bar. The fits for your 2017 Holiday Rambler Endeavor motorhome with V-Ride suspension are the following:
-... view full answer...
I do see your Trimark 12054-37 came keyed alike so every one of this model was keyed alike from the factory. These types of locks are typically not able to have the cylinder replaced as they made other models like the 16801-01 which used their KeyOne system and allow for cylinder exchanges. Trimark will tell you to just replace the entire latch assembly since they are all keyed alike. If you prefer to switch to a lock where they will be keyed differently than every other Trimark baggage... view full answer...
You can easily replace the thermostatically controlled RV ceiling fan you have in your 1999 Holiday Rambler Endeavor 37WDS with one that does not have that feature. We have the Ventline Ventadome Trailer Roof Vent part # V2094SP-28 which fits the standard 14 inch by 14 inch rough cut RV roof opening and has a fan without a thermostat. view full answer...
For your power step on your 2008 Holiday Rambler Endeavor, you will need the Replacement Control Module for Lippert Electric Coach Step # LC301702 based on my research. Your description sounds like a coach step and the attached photo is of a step like what I believe you have. I've also attached a video to assist. view full answer...
For your 2003 Holiday Rambler Endeavor that is built on a Roadmaster Monaco R chassis we have the Roadmaster Reflex Stabilizer part # RM-RBK6-RSSA which is a confirmed fit and will work well. view full answer...
The ".c" you are seeing on the display of your P2 part # 90885 indicates that your controller is sensing a trailer connection. As long as you have a trailer connected when you see this it sounds like everything is fine.
If you see ".c." instead (note there is a second decimal point), then the controller senses a trailer connection and the boost feature is engaged. The boost feature means the braking power will come on a bit more aggresively. view full answer...
For your 2009 Holiday Rambler Endeavor the Atwood AC Unit part # AT15028-22 would be a great option that will work well. It's ducted so it will fit right to your motorhome, it is rated at 15k btu so it has great cooling capacities, and it has a heat pump like you need as well. The drain system of this unit will match what you have on your motorhome as well. view full answer...
In order to pick out a direct replacement for the landing gear on your trailer we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Bulldog Tandem Landing Gear Set # BD500162. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets of the #... view full answer...
If you're referring to the internal 10 amp fuse in the top of the High Pointe Over the Range RV Convection Microwave # HP94ZR there have been owners who found that the door latch has two switches that wear over time and and end up causing the fuse to blow. Replacing these switches should clear up the issue. view full answer...
The Atwood Air Command Rooftop RV Air Conditioner w/ Heat Pump # AT15033-22 comes with everything you'll need to install it on your 2009 Holiday Rambler Endeavor that has the roof duct system already present. view full answer...
The correct Kwikee Step Motor Replacement Kit for your 5973820 on your 1999 Holiday Rambler Endeavor is part # LC379608. We confirmed this with Lippert.
I checked out the answer page that you referenced and the customer was asking about the Kwikee Motor # LC379147 which is different than the motor in the correct Replacement Kit # LC379608. This is why we said that the motor wouldn't work. view full answer...
Currently the only option we carry for the Domeic 300 Series is the Replacement Toilet Seat and Lid for Dometic 300 Weekender RV Toilets - Tan # DMC99FR.
I want to say that the 300 series was discontinued due to a issue with the gaskets leaking foul odors from the black tank but I could be wrong. If this is the series that was discontinued you'd be looking at possibly replacing the whole toilet unless you can find another replacement somewhere else or from Dometic directly. view full answer...
We do have a large selection of RV water tanks currently available. In order to choose the correct tank, I recommend simply taking a few measurements on your existing tank or on the space you have available for one. Our available tanks from Valterra all feature an 8 inch width and 16 inch height, but vary in their lengths and capacities.
For example, the Valterra RV Water Tank # RB042 measures 42 inches long and has a 21 gallon capacity. This is a really nice option for storing fresh... view full answer...
Go To Results